Differences

This shows you the differences between two versions of the page.

--- tip_of_the_day:5:5 [2012/04/11 11:46] – created Jan_K
+++ tip_of_the_day:5:5 [2018/12/28 00:17] (current) – clarified the explanation, there are still unclear / hard to understand sentences where I did not get the intended meaning, please check! Laudrin
@@ Line 1: / Line 1: @@
 <note tip>
 **Sequence 1st. step.**\\
-Creating a sequence it is a god idea to consider what has to be set in the 1 first step.\\
+If you start creating a sequence, it's a good idea to consider what has to be set in the first step.\\
-If there are a lot of shifting cues for example with Sub Master then the state where the new sequence starts can be unknown.\\
+If there are a lot of shifting cues for example with submasters, then the state where the new sequence starts can be unknown.\\
 \\
 Example:\\
-When a new sequence with parcans are started then all parcans are closed. In the first step two red parcans are set to full light. \\
+When a new sequence with parcans is started, then all parcans are closed.\\
-In the sequence only the change is recorded meaning the two red is set to full light.\\
+In the first step two red parcans are set to full light. \
-Unfortunately running the other cues left all parcans on.\\
+But because the sequence editor only records the changed values, the other fixtures may still be activated. If this is not intended, you'll have to change the intensity channel of the other parcans to //snap// or //fade// and it's value to 0.\\
-So trying to run this new sequence in the cue start with only sending values to the two red parcans that they are to be full on.\\
+If this behaviour is intended, you can start the sequence with only sending full intensity values to the two red parcans.\\
-As all parcans was left on from the last cue nothing will happen all light are still on.\\
+When all parcans were left on from the last cue, nothing will happen to them as the new sequence starts. So you combined the old light scene with a new one (two red parcans turned on).\\
 The first step could be made turn on all parcans, turn off all except the tow red, and then the next step can be made.\\
 In the sequence 1st step all parcans value are changed and therefore saved in the first step.\\
@@ Line 15: / Line 15: @@
 In the next step the settings are known. Only the two red are on and therefore only the ones that are wanted to be changed has to be set.\\
 The same issue can be seen on CMY or RGB control. In the first step set all 3 colors not just one.\\
+\\
+More tips: [[:tip_of_the_day|]]\\
 </note>