TRI LED - Starville

[matt]

This is the fixture file for the StarVille TRI LED. This fixture file is for DMX mode 4 ONLY.

- Untested..

uses the RGB Segment feature

[matt]

Make sure you set to Mode 4.

You can control the devices individually via your DMX-controller. Press
“MODE” button until it shows , this means DMX address is 001, you can
set the DMX address by “UP” and “DOWN” buttons. If press “SETUP”
button, it will show d-p1, it means the device is in which DMX mode 1. You
can switch these DMX modes by “UP” and “DOWN” buttons. There are 7
DMX modes.

[Risingscale]

Here is the shot



I'm waiting for my enttec dmx usb pro to test the file.
Thank you very much Matt.

Phi

[nomic]

did you test it?
how it works?
you need to have 5 fixtures for eatch Stairville Stage TRI ?
how do you adress the dmx if you can only adress one dmx adreess to eatch Stairville Stage TRI?
i am very newbie... and a bit confuse....