I am trying to set a button so that it runs a sequence of instructions. One is going to be:
- stop submaster 1
- stop submaster 2
- stop submaster 3
- set a range of DMX Channels (say 80-93) to be value 0
So they will run from one button (I'm working with an LJ who is used to a Masterpiece and is looking for as similar experience as possible).
Is there a way of stacking commands (as listed in the external commands list in the wiki) up to run from one key trigger?
Custom command programming
Forum rules
Please do NOT post bugs here! If you spot a potential Bug please report it HERE first then you can chat about it with other users in the appropriate section.
Please do NOT post bugs here! If you spot a potential Bug please report it HERE first then you can chat about it with other users in the appropriate section.
-
soundsinvision
- Starting to get to grips with FreeStyler
- Posts: 19
- Joined: 22 Dec 2015, 15:10
- I Use FreeStyler for: Nightclub Lighting
- Twitter: www.twitter.com/soundsinvision
-
Partyman
- FS is my life
- Posts: 788
- Joined: 11 Jul 2007, 20:39
- FreeStyler Version: 4.01
- I Use FreeStyler for: Nightclub Lighting
- Twitter: twitter.com/
- Contact:
Re: Custom command programming
It can be done but not the way you are thinking. You would have to make a cue that affects all the fixtures you are trying to control. If submaster 1 controls par cans then your cue would tell the par cans to turn off. Cues cannot be made to control submaster, sequences or Override Buttons, only fixtures.