Chase

[Tom]

Hi,

I have lots of lights in something I am currently doing and when I click to create a new chase, every single attribute on every fixture (from par can to martin mac) gets selected as "snap" and turns yellow to match. This means that I can't run multiple cues. For example.

Let say I have 8 parcans 1 - 4 and 5 - 8.

I record a chase on 1 - 4 and by default 5 - 8 are set to snap. (With no value as in the light is off). I then record a chase on 5 - 8 and by default 1 - 4 are set to snap with no values. However I can't run both chases together. Because when I run the 1 -4 chase it sets 5 - 8 to snap to 0, and then when I try and add in the 5 - 8 chase it will snap the lights in the 1 - 4 chase to off.

In this production I can't just go round turning every value off because I have about 100 lights and it would take too long.


Hope that makes sense.


Tom

[Partyman]

At the bottom of the sequence creator box there is an option for static or transparent. You are currently using static, recreate your scenes using the transparent mode.

Rusty

[Tom]

The same thing happens in transparent mode. I swear with older versions they were set to off by default regardless of the mode.