Stairville PAR56

[Mattotone]

Stairville PAR56

[cantyco]

I think you missed typed the subject as its a par 56, but thats just a small note.

If anybody buys the Stairville PAR64's like i ahve the 56 fixture file is identicle, and as i just proved works perfectly fine with my new ones lol


Hi Mattotone just wondering if you had made a scan libary entry for the par 56 for easyview? i tryed to make one, but i can;t find out the correct way to setup channel 1, set it up like a dimmer the same way freestlyer handels it but that only shows the colours when on full which isnt correct really...?

any help would be appriated..

[Mattotone]

When i created the fixture, i set ch1 as an intensity channel with the range of the manual function.
This is so i could use it with the DMX400

easyView Settings
number of channels 5
liabary type par 56
beam angle 30'
CHANNEL TYPE NAME
channel 1 Free Function
channel 2 RGB RED RED
channel 3 RGB BLUE BLUE
channel 4 RGB GREEN GREEN
channel 5 FREE Speed Functions

[cantyco]

Thanks Matt,

I figured it, its cause i set it up as a dimmer channel to start with, and then i changed it but didnt realise had to take the light out and put it back in easyview.

Thanks

[kikabyte]

Hi, for the sake of saving me a few mins,could someone forward me the Easyview file for these pars, or upload it here.

Thanks in advance
Chris

[cantyco]

yeah i should be able to do this when i get to my laptop tonight.

Tim

[cantyco]

Hi, it wouldnt let me upload the ssl file.

If you pm me with your email address i'll email you it.

[djSupport]

is that the correct extension for easyview files?? is that a bit like the exported fixture files of fs?? (dont use easyview 3d as you can tell lol) if it is I'll add it so you can upload those files.

[cantyco]

as far as i know it is... there isnt an export in the scan libary so i assume it is the exported file version