Overide Buttons

[biggus]

Ok not sure if this is me been thick or if there is a problem. Please see below my overide buttons. Currently if I have the "Twisters All White" button selected and then if I press the "Twisters All Red" button the "Twisters All White" will come deselected and so on that is how I want it to work.

However if I select "LED Cans All Pink" then want to change it to "LED Cans All Blue" the "LED Cans All Pink" will still be selected/lit up and I have to press it again to switch it off, How can I get it to work like my twister buttons below.



Notes:
The twister buttons don't have any Deselect all other buttons or flash buttons options enabled.

[Spirit]

it seems you recorded a Extra Channel to that sequence.

so open the sequence and look if a Other channel then Color is set to FADE.
or if you use the RGB channels for the ledpar be Sure you set fade to RGB on Each sequence.

/spirit

[DELighting]

The reason it doesn't work is most likely because you didn't program it right in the first place. The override buttons, only "override" things that you have recorded. If your led pars have a red channel, a green channel, and a blue channel, and you programmed your orginal cue with only the red channel, that leaves the blue and green channels open: (nothing recorded does not = record at 0) I'm guessing that when you hit the first override button as "all red" the le parcans go all red, just like they were supposed to. But, when you hit the "all blue" override button do your LED cans go purple? that's because the red is up in the first override button, and the blue is up on the second. If you had recorded your cues where you made sure to grab all three color faders then the buttons will work as you wanted them to. Just as in the post before mine, you have to make sure all three color channels are set to "snap or fade" or they are not recorded in the cue.