Bug with the 3.2.8

[apprenti bidouille]

Hello everyone !

I have a problem with the 3.2.8 version.
I used the patch to update my previous version. It worked well, freestyler opens and loads my programs... BUT : the "outputs" window is always full of "0" even when i load different programs or when i modify DMX values by hand... And of course Easyview sees nothing at all...
I can't test with my enttec interface since i don't have it with me... But i don't know how to recover a working Freestyler.
Of course I've tried to uninstall and reinstall a few times... No change...
At least, where can I download older versions ?

Thanks in advance if anyone can help me ?

Edouard

[dmxlighting]

Were you upgrading from version 3 onwards on before version 3?

[apprenti bidouille]

from version 3.x.x (don't remember exactly Sorry... ) But the problem still exists on a totally new install...

[Onge]

If you have an interface selected and it is not connected then they outputs do stay at zero. Well that is how it works for me using the Enttec Pro. Obviously no output to Easy View either.

If I select the Virtual Interface then all is good or if I connect my Enttec Pro and re-start FreeStyler all is good.

[apprenti bidouille]

OMG.. THANKS FOR THAT !!!

I never had to do this on previous versions of Freestyler, so i never suspected this..

Thanks again ! You save my life !

[Onge]

OMG.. THANKS FOR THAT !!!

I never had to do this on previous versions of Freestyler, so i never suspected this..

Thanks again ! You save my life !

No problem and I noticed according to your profile you are running a very special version of FreeStyler 6.2.1 ... hee hee hee

[apprenti bidouille]

No problem and I noticed according to your profile you are running a very special version of FreeStyler 6.2.1 ... hee hee hee

!! N00B spotted !!