Problem with Freestyler 4.0.1

[FALCETTA]

Good Evening I'm using freestyler version 4.0.1 but I'm having a problem!
in practice I want to edit a cues already made in strobe version and delete only the strobe leaving everything else unchanged, I do it except for the new chases but I don't understand why when I start it, it always starts with the strobe, it is as if it does not save the changes I made, how can I fix. thank you very much

[Partyman]

That version was pulled down because of some bogs, please download stable release on the download page

[FALCETTA]

thank you very much for the reply, I tried to download the "stable" version from the site but I have problems loading all the cues / sequences / etc etc from the other version, what should I do?

[xever]

Version 4.0.1 made some big changes to how the cue system works, and may contain many bugs.
New sequences are not backwards compatible im afraid.

[FALCETTA]

Ok what should I do then?
I saw that on the official Facebook page there is a 4.1.1 version, should I go to that one?
I guess they fixed some bugs in that version; or do I do it all over again by installing the "stable version"? even if it would be a big problem

Thanks so much

[Partyman]

Hmmm, All version 4.... have been recalled. I am not sure if that version is the problem version or an updated one that was not added to this forum. I will download it and see what I can figure out

[Partyman]

The problem versions were 4.00 and 4.01.
The version on the facebook page is 4.1 so i am assuming it is the updated version. I have not fully tested yet

[FALCETTA]

Thank you so much for the answers, so do you recommend that I try to install version 4.1? to restore all the settings of my current 4.0.1 just do backup / restore?

[Partyman]

definitely! Nothing lost by trying