Hey there!
First of all, sorry if this is a repost. I can’t connect my ARTNET to my FreeStyler 3.5.9.
Unfortunately, everything in my country is very expensive so I must build my own tools
I got my interface from http://www.deskontrol.net/blog/nodo-art ... n-arduino/
I used an Arduino UNO, a SHIELD ETHERNET W5100 and a MAX485.
My computer runs with Windows XP 32bits. I configured the port
IP 2.0.0.1
Sunet-mask 255.0.0.0
Gateway 2.0.0.1
just like the tutorial explained.
I downloaded DMX-Workshop to check if there was a problem with the connection between the FreeStyler and the interface.
By using the Transmit Preset tool I can send a signal to my both Par Led RGB without any trouble.
Am I using the correct configuration for the FreeStyler?
If someone could give me a hand, I would really appreciate it!
Sorry for my lack of knowledge.
Thanks in advance!
Regards,
Problem with my DIY Artnet [Solved] Topic is solved
-
- Knows how to turn Lights ON
- Posts: 3
- Joined: May 26th, 2015, 4:00 am
- FreeStyler Version: 3.5.9
- I Use FreeStyler for: Just for the Fun of it.
-
- Knows how to turn Lights ON
- Posts: 3
- Joined: May 26th, 2015, 4:00 am
- FreeStyler Version: 3.5.9
- I Use FreeStyler for: Just for the Fun of it.
Re: Problem with my DIY Artnet [Solved]
I configured wrong FreeStyler !
Thanks you !!
Thanks you !!
-
- Knows how to turn Lights ON
- Posts: 1
- Joined: April 13th, 2016, 6:23 pm
- FreeStyler Version: 3.6.3
- I Use FreeStyler for: Stage Show
Re: Problem with my DIY Artnet [Solved]
Hi foxfox, i'm doing the same project and it's not working at all.
I have tested my DMX output and it works fine.
An Arduino UNO, an ethernet shield W5100 and a MAX485 like you.
Same adress om FreeStyler V. 3.6.31
Can you help me?
Regards!
I have tested my DMX output and it works fine.
An Arduino UNO, an ethernet shield W5100 and a MAX485 like you.
Same adress om FreeStyler V. 3.6.31
Can you help me?
Regards!