I have an Enttec USB Pro that does something odd. With a bit of electrical noise (like a fan or motor switching on and off), and sometimes even without it, the interface will stop responding and the green light will flash dimly. Stop FS, re-plug the interface, and it works some more.
Anyone seen this behavior from one of these? I figured the isolated DMX output would help avoid this kind of trouble, but it seems maybe not.
Strange behavior out of Enttec USB Pro
-
tjobrien21
- Starting to get to grips with FreeStyler
- Posts: 19
- Joined: 23 Nov 2009, 20:58
- FreeStyler Version: 0
- I Use FreeStyler for: Just for the Fun of it.
- Twitter: twitter.com/
-
JTR
- Knows how to turn Lights ON
- Posts: 7
- Joined: 03 May 2011, 10:52
- FreeStyler Version: 3.3.2
- I Use FreeStyler for: Where do I start?
Re: Strange behavior out of Enttec USB Pro
My understanding is that the entec pro uses the FTDI chip as a USB bridge to its onboard micro. That being the case this (top sticky) thread here may be of some use. http://www.freestylersupport.com/fsforu ... f=10&t=332
-
tjobrien21
- Starting to get to grips with FreeStyler
- Posts: 19
- Joined: 23 Nov 2009, 20:58
- FreeStyler Version: 0
- I Use FreeStyler for: Just for the Fun of it.
- Twitter: twitter.com/
Re: Strange behavior out of Enttec USB Pro
Hey thanks for pointing that out! I'm a technical type, that's well within my capabilities. I might just give it a go. 