Addressing Problem?

[3cprod]

Sorry, I'm a newbe- so this might be a stupid question, but I can't figure this out. I have 8- Eternal Lighting ETL-904-FlatPar hooked up sequentially to each other. I start addressing at the first in line. In the last fixture, I have a DMX terminator. Problem is, when I select all fixtures- I don't get the last fixture. However, when I run the macro that someone wrote for these, it only controls the last fixture (that wouldn't work with the others.) Is this enough info to go on? Thanks in advance to anyone, I am really stuck!

[Spirit]

no i do not realy understand, can you upload the .pff file from your fixture.
1)did you patch all your fixture's right?
2)did you add 8 fixtures in Freestyler?

[3cprod]

Yeah, I've got it. A DJ wrote it and emailed it to me. When I imported it, I guess the flashing macro was with it. I have each fixture plugged in to the next one for all 8, with the terminator in the last one. I have 8 fixtures set up- and do a "Select All". When I just do a color, or something simple like that, that last one doesn't work. Do you want me to send the .pff to you?

[Mavi]

Did you set up the DMX Starting address to all fixtures right?

[3cprod]

Yep. They are all right.

[Spirit]

what happins if you select all your fixtures and drag the slider on the right of the screen.

did you already lookt at your kabels maby the last kabel is a bad one.

yes you can send me the .pff or upload it this topic.

[3cprod]

I figured it out. Somehow, the setting on the light for that one fixture was set to 6 channels. All of the other lights were set to 3 channels. When I set it at 3, everything worked. Sorry for bothering you on this.