Problem with my DIY Artnet [Solved] Topic is solved

[foxfox]

Hey there!
First of all, sorry if this is a repost. I can’t connect my ARTNET to my FreeStyler 3.5.9.

Unfortunately, everything in my country is very expensive so I must build my own tools
I got my interface from http://www.deskontrol.net/blog/nodo-art ... n-arduino/
I used an Arduino UNO, a SHIELD ETHERNET W5100 and a MAX485.
My computer runs with Windows XP 32bits. I configured the port
IP 2.0.0.1
Sunet-mask 255.0.0.0
Gateway 2.0.0.1
just like the tutorial explained.




I downloaded DMX-Workshop to check if there was a problem with the connection between the FreeStyler and the interface.




By using the Transmit Preset tool I can send a signal to my both Par Led RGB without any trouble.




Am I using the correct configuration for the FreeStyler?



If someone could give me a hand, I would really appreciate it!
Sorry for my lack of knowledge.
Thanks in advance!
Regards,

[foxfox]

I configured wrong FreeStyler !




Thanks you !!

[Phil_bob]

Hi foxfox, i'm doing the same project and it's not working at all.
I have tested my DMX output and it works fine.

An Arduino UNO, an ethernet shield W5100 and a MAX485 like you.

Same adress om FreeStyler V. 3.6.31

Can you help me?

Regards!