Differences

This shows you the differences between two versions of the page.

--- suntrix_and_ledtrix_how_to_setup_window [2011/03/07 08:51] – Jan_K
+++ suntrix_and_ledtrix_how_to_setup_window [2011/10/19 16:38] (current) – removed Spirit
@@ Line 1: / Line 1: @@
-====== LedTrix – Setup Window ======
-Instead of describing the parameters that can be set in the “Setup window” and example has been made.
-In the example I have used 8 x ”Kam Led 800 Stripline” to create an 8 x 8 matrix.
-{{:ledtrix_kam_matrix.jpg|}}
-Each Kam has 8 segments that uses 6 DMX channels for control.
-The 6 channels looks like this bellow.
-With LedTrix we only want to control the colors because it is a tool to display graphics meaning that only 2, 3, and 4 are of interest.\\
-A whole Kam stripline uses 6 x 8 = 48 addresses and whole matrix of 8 Kams uses 8 x 48 = 384 addresses.
-Note:\\
-I a case where only 3 channels are used to control each segment DNX 512  = 512 addresses can control 170 segments and this gives a matrix of max 13 x 13.
-{{:ledtrix_kam_ch.jpg|}}
-Kam LED 800 Stripline Set to 8 segments
-{{:ledtrix_kam.jpg|}}
-All Kams are placed with DMX addresses next to each other. See the figure.\\
-This gives a start address = 2 because it is the first red segment.\\
-And for every 3 addresses we are to skip 3 to get the next red segment.\\
-Bellow these values can bee seen.\\
-As the first segment in the matrix is upper left corner the mode “Mode” entry is set to this.\\
-Remember to press the “Auto address” button”
-Looking on the color / address window the addresses can be checked.\\
-First Kam, segment 1 has adr. 2, 3, 4 and segment 2 has adr. 8, 9 and 10.\\
-This correspond to the drawing above.\\
-{{:ledtrix_setup_01.jpg|}}
-{{:ledtrix_image_offset_00.jpg|}}
-{{:ledtrix_image_offset_auto.jpg|}}
-{{:ledtrix_image_spacing_00.jpg|}}
-{{:ledtrix_image_spacing_01.jpg|}}