Differences

This shows you the differences between two versions of the page.

--- fixtures:adding_and_removing_fixtures [2019/01/29 06:51] – [Remove fixtures] Jan_K
+++ fixtures:adding_and_removing_fixtures [2019/01/29 06:59] (current) – [Options] Jan_K
@@ Line 147: / Line 147: @@
 Before you removing a fixture it is a good idea to consider what will be affected by this removal. If the fixture never has been added / programmed into a sequence then just remove it.\\
 But in the case where it has been programmed into a sequence then it will be a good idea to clean up the sequences.\\ This is to avoid a new fixture with another DMX table to be controlled by a sequence which is not programmed for it. It will mess-up your control.\\
-So the advise is clean-up the sequence before removing the fixture.\\
+So the advise is clean-up the sequence before removing the fixture. [[fixtures:adding_and_removing_fixtures#Cleanup sequences.|]]\\
-[[fixtures:adding_and_removing_fixtures|]]
 \\
 \\
-{{:fixtures:fixture_library_remove_2.jpg?|}}
+{{:fixtures:fixture_library_remove_2.jpg?|}}\\
+\\
-As you can see the fixture has been removed from the list on the right.
+Click on the remove arrow and as you can see the fixture has been removed from the list on the right.\\
 You can now close this dialogue.\\
@@ Line 190: / Line 189: @@
    *Release locked
 \\
+\\
+------
 \\
 === Cleanup sequences. ===
@@ Line 198: / Line 199: @@
 \\
 \\
+------
 \\
 === Print fixture list. ===