Support Forum

Hello all,

I have a problem i cannot figure out. I have a double moving head with 15 channels. The heads can be controlled seperately because both heads have a different dmx channel for pan and tilt in 15 channel mode.
I need to be able to use the pan of the heads in mirror. As fixture creator doesn't allow multiple channels for pan and tilt i cannot figure out how to do this in one file. I have added the channel list below.
Hope someone can help me

Regards

Andre.

The channel layout is most unfortunate. With other fixtures such as this the solution is to define multiple fixtures. In this case it would be 3 fixtures. 1 fixture for pan/tilt of one head. Another fixture for pan/tilt of the other head and a 3rd fixture for the rest of the functions. This will not work with this fixture due to the pan/tilt channel layout. I think the best you can do is define a 15 channel fixture with one head as pan and tilt, say channels 1 and 2, and just label channels 3 and 4 and use the sliders in the upper right hand corner to position the 2nd head. The other functions can be defined as usual.

Good luck.