Support Forum

I have a Colorsplash 196 and can't create it! It has 7 channels - all 7 of which are rgb control.

1 - red 0-100%
2 - green 0-100%
3 - blue 0-100%
4 - red 0-100%
5 - green 0-100%
6 - blue 0-100%
7 - red 0-100%

I can't figure out how to create this fixture. I have even tried to cheat and create two fixtures, but this doesn't seem to work either.
Please help! Thanks.

in the manual said that? beacause it's impossible use 3 channels Red and only 2 Green/Blue. the first or the last channel normaly is a shuter/intensity/pré-Prog channel... try to teste creating a dimmer pack with 7 channels...and test one next another.
Or you have more than 7 channels, it means that you can test creating a max of channels (33), and see what channels do in your fixture.

Set your fixture to the channel 1, create a dimmer pack with 33 channels, set it to the first channel, move the sliders on the rigth one by one to see.

cumpr

aquas wrote:in the manual said that? beacause it's impossible use 3 channels Red and only 2 Green/Blue. the first or the last channel normaly is a shuter/intensity/pré-Prog channel... try to teste creating a dimmer pack with 7 channels...and test one next another.
Or you have more than 7 channels, it means that you can test creating a max of channels (33), and see what channels do in your fixture.

Set your fixture to the channel 1, create a dimmer pack with 33 channels, set it to the first channel, move the sliders on the rigth one by one to see.

cumpr

Well its weird but actually it is correct, those 7 channels.
At least, according to this manual: http://www.chauvetlighting.com/products ... ug-126.pdf

bendigo, you need to create a 7 channel parcan/dimmer in the fixture creator. And ofcourse, when it works, you post it here. Right?