Support Forum

Hello, I have a somewhat complex problem, I have 16 - parleds, all being the same and from the same manufacturer.
it happens that some of these parleds(3) are not working with Freestyle, however they work with Q Light perfectly, the DMX command arrives correctly, the channels are separated, even putting in channels that another parled that is working correctly the 3 parleds do not work , but they all work with the Q light controller.

would anyone know a solution to this problem?

I've tried all sorts of freestyle configurations and I couldn't get it to work.

follow channel specifications

Channels
1 - DIMMER
2 - RED
3 - GEEN
4 - BLUE
5 - STROBE
6 - EFFECTS

I don't understand a lot of English, I'm using google translator, in case something doesn't work, that's why.

change the dmx values manually, if you know what you are doing and there is no effect you may have 2 problems:
the controller you are using with freestyler doesn't work properly
You don't have right connections on the DMX bus, check it, check if the pin 2 and 3 of XLR connector maybe are somewhere reversing (they should not), at the end of line put a 120ohm resistor between 2 and 3