Robe ClubSpot 150CT Mode 1/2/3/4 (Moving head)
Posted: October 12th, 2008, 11:59 pm
(new user of Freestyler checking in here) 
Fixture files for: Robe ClubSpot 150CT Mode 1/2/3/4
Tested: No
Gobos: Exact copy from gobo wheel
Colors: Should be near real life
Default mode: Mode 1 (The fixture defaults to mode 1 if it is new from the factory).
Recommended mode: Mode 1 or 2.
Website of manufacturer: http://www.robe.cz/ Direct link to fixture
I did not test these files yet. Because I don't have these (or any) fixtures by myself.
I will be able to test them in december 2008 (lightshow with rented equipment). But for now, here are the exported fixture files for the Robe ClubSpot 150CT in all available DMX modes this fixture supports. Mode 1(8ch),2(8ch),3(6ch) and 4(6ch).
Mode 1 and 2 are 16 bit Pan/Tilt modes.
If by accident anybody can test these fixture files (only mode 1 is enough), then I will be greatfull.
I really have no idea if these fixture files will work in reallife, I hope and think they do. Never used Freestyler on a real DMX line yet. That will be done in december 2008, as a test. An SGM DMX controller will be the backup.
Fixture files for: Robe ClubSpot 150CT Mode 1/2/3/4
Tested: No
Gobos: Exact copy from gobo wheel
Colors: Should be near real life
Default mode: Mode 1 (The fixture defaults to mode 1 if it is new from the factory).
Recommended mode: Mode 1 or 2.
Website of manufacturer: http://www.robe.cz/ Direct link to fixture
I did not test these files yet. Because I don't have these (or any) fixtures by myself.
I will be able to test them in december 2008 (lightshow with rented equipment). But for now, here are the exported fixture files for the Robe ClubSpot 150CT in all available DMX modes this fixture supports. Mode 1(8ch),2(8ch),3(6ch) and 4(6ch).
Mode 1 and 2 are 16 bit Pan/Tilt modes.
If by accident anybody can test these fixture files (only mode 1 is enough), then I will be greatfull.
I really have no idea if these fixture files will work in reallife, I hope and think they do. Never used Freestyler on a real DMX line yet. That will be done in december 2008, as a test. An SGM DMX controller will be the backup.