Page 1 of 1
FreeStyler strobes light, Rockford Keeps the light on.
Posted: January 12th, 2022, 4:49 am
by jjthomas
I'm using FreeStyler 4.1.1 on Windows 10, connected to ultraDMX Micro Interface using DMXking USB DMX512-A interface. The fixture I'm writing about is DJ Lights Moving Head U`King Mini LED Moving Head Light RGBW.
When I use my Rockford Rockville ROCKFORCE 384 Channel Fog DMX Lighting controller, I set channel 7 to zero, the fixture stays on. When I set Freestyler, channel 7 to zero, the fixture strobes. I have two fixtures and the result is the same for both fixtures.
I'm not sure this is a bug or a setting error on my part.
Any suggestions on how to set FreeStyler so the light stays on and does not strobe?
Thank you.
-JJ
Re: FreeStyler strobes light, Rockford Keeps the light on.
Posted: January 12th, 2022, 8:21 am
by Jan_K
One way to debug the issue id to open the output window in FreeStyler.
There you can see what FS is sending to your fixture.
And then you need to match it with the addresses / dmx table on your fixture.
Remember there may be an error in the fixture file so it may be an idea to use the right side faders during debugging.
Re: FreeStyler strobes light, Rockford Keeps the light on.
Posted: January 12th, 2022, 8:58 am
by jjthomas
Thank you. I'll give that a try. I'm building a fixture file, via Fixture Creator, it will help me to understand how the process works. I did not how to debug, I'll give that a try, as well.
-JJ
Re: FreeStyler strobes light, Rockford Keeps the light on.
Posted: January 13th, 2022, 11:17 am
by Jan_K
Simple suggestion on how to debug.
Connect only 1 fixture.
Check that the address in FreeStyler and Fixture are the same.
Use the right side faders to check that the fixture does what is listed in the DMX table.
light on, pan tile movement and the last channel specially to check the mode
Check if the fixture profile works correct.
If the fixture profile doesn't work then compare the output value with the fader value and with DMX table
Re: FreeStyler strobes light, Rockford Keeps the light on.
Posted: January 14th, 2022, 8:56 am
by jjthomas
Thank you. I am having to RTFM (Read The Fine Manual). Having the DMX output window helped solve the strobing problem. The way the fixture was set up, FreeStyler could not send a "0". I rebuilt the fixture from scratch. That solved that problem.
-JJ
Re: FreeStyler strobes light, Rockford Keeps the light on.
Posted: January 22nd, 2022, 7:07 pm
by RobTjotji
How do you delete a message?
I found the answer in another post.
Thanks anyway.
Re: FreeStyler strobes light, Rockford Keeps the light on.
Posted: January 25th, 2022, 6:06 am
by jjthomas
I'm an old SYSOP, from CompuServe... very old... But I would just add a single line to the end and say I fixed it, and put up the solution.
Hmm I see that I didn't do the best job, above.
What I did was set the off option to 1 like as follows:
FreeStyler012422FixStrobe.png
-JJ
WOW my attachment sucks...