Channel 5 sets the mode:
- Normal strobe light, LEDs controlled independently.
- Normal strobe light, LEDs controlled simultaneously.
- 4 different pre-programmed patterns.
- 2 different sound activated patterns.
In the simultaneous mode channels 1-2 control: LED 1+2 brightness; LED 1+2 speed.
OK so far … I can do something and ignore channels 3 and 4.
But: for the 5 different pattern modes you only have control of speed, which is set by Channel 1. So depending on Mode, Ch1 has different functions.
So far I've created 8 macros for the Modes: Independent, Simultaneous, P1, P2, P3, P4, Sound 1, Sound 2 - and four Custom Sliders for Ch1- 4. As there isn't much room for text on the sliders - and Ch1 changes function depending on mode - it looks messy.
Any ideas how to make this neater?