Can't figure how "Pan/Tilt resize" feature works
Posted: 22 Apr 2017, 18:12
Hello,
I'm new to FS, I slowly start building​ shows using Submasters, cuelist and override buttons, still I'm facing an issue : how to adapt my scan positions to the room ? (I'm a lightjockey for a DJ, I use a basic Starway Director console but I'm willing to upgrade things up)
I found the Pan/tilt feature but can't figure out how to use it...
I searched before on the forum but I didn't find my answer so I'll try to explain my issue :
First I set a limit for the Pan in the Pan/Tilt resize feature. (I set something like 5% 5% to be able to notice the difference)
Then, I launch a cue containing 2 steps (1 : light all the way right, 2: light all the way left), and my fixtures (ROBE DJ Scan 250 XT) just don't care about the "Pan/Tilt resize" limit I set.
I'm sure I missed something to make this feature works, but I can't figure out what.. So, any help would be welcomed
Thanks by advance !
EDIT : I forgot to mention that I'm in virtual mode (i'm trying out the software and then I'll be a Enttec) so I visualize the show in Magic3D and "Show output" (where I saw that pan values keep moving too much)
I'm new to FS, I slowly start building​ shows using Submasters, cuelist and override buttons, still I'm facing an issue : how to adapt my scan positions to the room ? (I'm a lightjockey for a DJ, I use a basic Starway Director console but I'm willing to upgrade things up)
I found the Pan/tilt feature but can't figure out how to use it...
I searched before on the forum but I didn't find my answer so I'll try to explain my issue :
First I set a limit for the Pan in the Pan/Tilt resize feature. (I set something like 5% 5% to be able to notice the difference)
Then, I launch a cue containing 2 steps (1 : light all the way right, 2: light all the way left), and my fixtures (ROBE DJ Scan 250 XT) just don't care about the "Pan/Tilt resize" limit I set.
I'm sure I missed something to make this feature works, but I can't figure out what.. So, any help would be welcomed
Thanks by advance !
EDIT : I forgot to mention that I'm in virtual mode (i'm trying out the software and then I'll be a Enttec) so I visualize the show in Magic3D and "Show output" (where I saw that pan values keep moving too much)