Support Forum

Hello,

I've searched the wiki, I've combed through the forum, but I've been unable to find a solution to my problem.

I've patched all of my fixtures.
I've built my sequences.
I've entered my cues.

What I can't seem to to is get a cue to run.

When I click the little "play" button, in the cue pane, I can see it move through the sequence steps, but nothing happens on the desktop, nor my actual fixtures.

What am I missing?

What interface are you using?

Enttec open DMX.

But, the % values don't even change on the desktop.

If you open the freestyler output window to view dmx output do you see anything change there?

No.

I clicked the play button for each cue but the output window info never changed.


Maybe I'm recording the cue wrong?
Create Sequence
Set fixture levels, make sure "fade" is on, (all conventional fixtures at this point - simple fade on or off)
Save as...

Click "Cue"

Click the play button for what I just created,

and nothing happens.

I think it is time that we look at doing some video tutorials....it will make things a lot easier IMO.