Support Forum

Hello everyone, I came from bulgaria dmx usb interface tonight I've done some testing, I have a question (I hope at least answer me this) my question is this ..

Let's say I have 2 cues one set of LED par and 2 for a moving head ..

then I put in play the cue 1 (par led) then I want to go to the mobile head, then stoppo cue 1 and cue 2 I play in, BUT the cue 1 (ie, par), I remain always on, is this normal? does not seem like a very pleasant thing .. if I wanted that when a cue stoppo its headlights turned off as I do?? thank you very much

It's normal behavior. You turn on the lights, so you should turn them off. Stopping cue doesn't turn off anything.

Simplest way:
At first step of second sequence set all unused values to zero (move sliders to right then to left for to be sure, they are setted to zero)
I always start programming each new sequence from setting all values to zero.

In other way - I think if in fixture configuration is "default value" set to 0 - then stopping cue should turn off the lights, but i,m not sure. I have to check it.

thank you very much for your reply.

you mean the first step of each sequence to set it all off? you give me an example?

Where can I find the default value? controllarco you? thank you very much ..