Support Forum

Hi, so Ill try and explain this the best I can. I have two chauvet intimidator led 300's and two chauvet colorrails that I use with Freestyler (current update). Ill make a sequence for the scanners that has color changing and head movement and insert that into the cue list, ill then make a sequence for the colorrails with basic color changing and insert that into the same cue list right below. When I activate both cues the scanners stop moving but resume color changing, as soon as I stop the colorrail sequence and allows the scanners to continue the scanners begin moving again, and when i start the colorrail sequence again they stop.....so basically anytime I activate the colorrail sequence it stops the scanners from scanning. I'm using the beziers shape maker in the pan/tilt options, and I made both the scanners and colorrails in transparent mode. I can't figure out what could be causing it, and its driving me nuts! Any help is much appreciated thank you!

even though you did not intend to you may have included the scanners in the colorrail sequence. Activate each sequence individually and see if a yellow asterisk pops up next to your colorrails AND your scanners while operating the colorrail sequences