Support Forum

hello all!

i need some help with a fixture
a few days ago a created a new fixture file for my beamz mhl-108
everything runs fine exept for macro's (i will use them only as rgb wash)
but i cant change the intensity in my submaster windows
is there enyone who can help me out, if the fixture is completed it can be shared with other users


channel 6 is used for the intensity and strobe (in the file its called dimmer)
0 - 7 = off
8 - 134 is intensity (8 is full 134 is lowest)
135 - 239 = strobe (higher is faster)
240 - 255 = full on

again everything is working like open\close, intensity, strobe is limited at 237 (238 and 239 are way to fast)
but i cant change the intensity in the submaster window, did not have this problems with my other led parcans

i cant upload the fixture file for some reason

thanks in advance

hi yes indeed i need you fixture file.

but go to FILE-> and EXPORT the fixture file this way you get a .PFF file and it somekind of .zip file it also contence all the images

and a .pff should be upload to the forum

/spirit