Support Forum

Hi everybody!
A few days ago I built a profile for a Chauvet Intimidator spot LED 150. I went through and added gobo pics, colors, the whole 10 yards. I saved the profile and then exported. I went to load the fixture into Freestyler and I received a message "INTIMIDATOR SPOT LED 150.fxt : Input past end of file". I'm not sure what I did wrong but I would like to find out so I don't mess up any future fixtures. Thanks for any help you can provide! I attached the .pff file that was exported for anyone that would like to review it.

hi

the input end of file doesnt make it possible to look in the File anymore.

But i realy like it you tried to create your own Fixture file (Trucktrail7 Rocks! )

But this fixture is allready created and can be download for the Complete LIB file.
viewtopic.php?f=23&t=4528

/spirit

Thank You! I didn't realize it was already there. I will go get it then. I will tell you what I noticed. If I build a profile without adding all the gobos and colors (simply add up total channels and change the descriptions), the profile works. But, like on this one, when I added colors and gobos, thats when that message came up.