Page 1 of 1
Chauvet Intimdator SCAN LED 200
Posted: 20 Aug 2012, 22:07
by thelodgemd
I used a fixture for the Chauvet Intimidator SCAN LED 300 (from this Forum) to try and create a fixture for the 200. I have gotten pretty far, but some things are not quite right - can someone give what I have done a look and give me any thoughts/changes. The fixture (in progress) and DMX codes 9as a two page PDF) are attached and the manual specs are below. Many thanks for your help! Ryan - The Lodge Nightclub
Intimidator200v2SCAN.pff
Intimidator_Scan_LED_200_DMX CODES.pdf
Re: Chauvet Intimdator SCAN LED 200
Posted: 21 Aug 2012, 06:56
by Jan_K
Hej.
You have strobe low = 130, high = 214.
The data sheet says 8 to 215.
Additional you have on "Gobo rot. 1" placed channel 7 Function.
It is some reset and control functions.
Think it is better to place them on macros.
The macros are better for fixed values
Also it is better to have function the sets modes and reset fixture, separated from the gobo control panel.
Please pin point if there are anything that don't work as expected then we can take it from there.
/Jan
Re: Chauvet Intimdator SCAN LED 200
Posted: 21 Aug 2012, 22:36
by thelodgemd
Thanks, Jan, for the help - I will continue on and post a new file with some specific questions. Again many thanks for your help and support as I learn. Ryan
Re: Chauvet Intimdator SCAN LED 200
Posted: 22 Aug 2012, 01:10
by thelodgemd
Jan,
It seems I'm not getting it. When I open the color bar...there is a slider to run through the color changes. Also there are color pictures/blocks so you can pick a color quickly. I updated channel 3 to match the DMX codes in the manual - and updated the color pictures. According to the manual, channel 3 has 20 colors - so I set the color channel to 3 and set the number of colors to 20.
When I am in freestyler, the color squares do not match what I programmed....and clicking the color squares produce different colors on the light (clicking blue makes the light pink)
Can you please look at my channel 3 programming and the chart that I completed - and hopefully you can tell me where I went very wrong.
Many thanks - Ryan
Re: Chauvet Intimdator SCAN LED 200
Posted: 22 Aug 2012, 07:58
by Jan_K
I have been counting colors on channel 3 there are only 18 or am I using a wrong manual.
DMX_CH3.jpg
I have changed the color wheel so it follows the table above.
I uses mid values so the color wheel alvays will be placed in the middle of a range.
IntimidatorScan200v4.pff
http://www.freestylersupport.com/wiki/f ... &s[]=value
/Jan