Support Forum

This is the fixture file for the StarVille TRI LED. This fixture file is for DMX mode 4 ONLY.

- Untested..

uses the RGB Segment feature

Make sure you set to Mode 4.

You can control the devices individually via your DMX-controller. Press
“MODE” button until it shows , this means DMX address is 001, you can
set the DMX address by “UP” and “DOWN” buttons. If press “SETUP”
button, it will show d-p1, it means the device is in which DMX mode 1. You
can switch these DMX modes by “UP” and “DOWN” buttons. There are 7
DMX modes.

Here is the shot



I'm waiting for my enttec dmx usb pro to test the file.
Thank you very much Matt.

Phi

did you test it?
how it works?
you need to have 5 fixtures for eatch Stairville Stage TRI ?
how do you adress the dmx if you can only adress one dmx adreess to eatch Stairville Stage TRI?
i am very newbie... and a bit confuse....