Need help with Fixture creator - Pre-programmed shows
Posted: 14 Sep 2010, 05:32
I have a light which is essentially the American DJ Mega Panel, an RGB panel. In 7 ch DMX mode, channel 4 in the fixture manual is p-re-programmed shows and channel 5 is the speed. I successfully created a fixture profile in fixture creator, but don't know where to put Ch 4 and Ch5. I tried putting them in the pan tilt section, but then they are on all the time. I'm thinking I can place them in the macros, but have no idea if that's possible or how to do it. Is there a Macros tutorial? I havn't been able to find one yet.
just for additional information, I only need to find a place to place Ch 4 and 5 that are easy to control and can be turned on and off when I want to switch between RGB mode or preprogrammed shows. Channel 5 controls the speed of the shows. Here is the channel listings for this fixture in 7 channel mode:
CH1 - Red
CH2 - Green
CH3 - Blue
CH4 - 001-239 Color Show
240-255 Sound Active
CH5 - Speed Adjusted
0-100%
CH6 - Strobe
CH7 - Master Dimmer
0-100%
All channels have been succesfully created in fixture creator except CH 4 & 5. Any suggestions?
just for additional information, I only need to find a place to place Ch 4 and 5 that are easy to control and can be turned on and off when I want to switch between RGB mode or preprogrammed shows. Channel 5 controls the speed of the shows. Here is the channel listings for this fixture in 7 channel mode:
CH1 - Red
CH2 - Green
CH3 - Blue
CH4 - 001-239 Color Show
240-255 Sound Active
CH5 - Speed Adjusted
0-100%
CH6 - Strobe
CH7 - Master Dimmer
0-100%
All channels have been succesfully created in fixture creator except CH 4 & 5. Any suggestions?