Hej DJ-Twitch.
There is one way to do this but it is a hard way.
Make a fixtur with 16 fader.
Then manually use the fade one by one and see what happens.
It is a bit tricky because some of them can have influence on the other.
Keep the once you don't use in 0 as long as possible.
Record where the changes are.
1 figure out the channal that turns on/ off the beam. It may also set the device to music control.
2 figure out the channals that change patterns. record the patterns eventually take a snapshot of the pattern and use it as icon in the macros. The may be a bank switch fader.
3 Then you have to figure out foom, rotating, strobe, movenents of the figure and of the moving head.
This can take a long time.
It is important that you don't change all faders at the same time because you don't know what happens then.
Also don't expect that the driver runs perfect from the beginning.
You may have to modify it many times.
/Jan
