Support Forum

Hello, i use freestyler with a bcf2000 and i noticed something last weekend

I was using a sequence that i set to "one time" instead of repeat
when the sequence ends the sequense remains on "play"
this required me to turn it off and on to use it again...

wouldnt it be better if sequences in this mode were automaticly stopped if its set to "one time" ?

Kind Regards,
Stefan Wempe


ps:

less important: when "one time" and "reverse" are both enabled the sequence wont run

horstefan wrote: Hello, i use freestyler with a bcf2000 and i noticed something last weekend

Cool - best way of using FS (in my opinion!)

I was using a sequence that i set to "one time" instead of repeat
when the sequence ends the sequense remains on "play"
this required me to turn it off and on to use it again...

Yeah it does do this. I think it was designed to 'stack' sequences and play one after another and notthe same sequence over and other again.

wouldnt it be better if sequences in this mode were automaticly stopped if its set to "one time" ?

I understand what you want here. I don't think it will be changed though. Try using the submasters and the cue window together instead.

less important: when "one time" and "reverse" are both enabled the sequence wont run

I tried this and my experience was that the sequence would run but not stop. It was ignoringthe 'run one time' and just looping the sequence.