Support Forum

why my scans are moving inversely than he 3d view? and when I invert the pan or the tilt, it reverse it too on the 3d, so I cannot trust the 3d to make my scenes...

There is an option in the 3d easy view to invert pan tilt.
Where all the fixtures and objects are listed next to each fixture is a invert pan and invert tilt option. try those to correct your problem.

I search to find a pan/tilt inverter in the 3d view, but I didn't see it, where is it?
I think this will solve my problem, thank you

it's ok I found it
it works now!