Support Forum

hey all,

my first problem is when i press blackout all of my lights go out in the easy view program apart from the martin mx-1s and when i click on the lamp settings and click close that still does not turn the light off

second is when i press blackout i would like one of the lights that runs on the dimmer to stay on is there any way i can do this? cheers

hi,
you need to create a group with the fixtures that you want to blackout. Than set a button in the keyboard shortcuts, "Blackout Group *". * is the number of the group you create, so in the list is ascending 1 to ...

When you use the defined button than only blacks the fixtures you select.

cumpr

cheers that sorted the second problem any one got any ideas on the first one? cheers

gareth wrote:hey all,

my first problem is when i press blackout all of my lights go out in the easy view program apart from the martin mx-1s and when i click on the lamp settings and click close that still does not turn the light off

if you like, maybe you can fix it by changing the fixture in scanlibrary for magic 3d.

second is when I press blackout i would like one of the lights that runs on the dimmer to stay on is there any way I can do this? cheers

you can as already said us the blackout group. you can also go to "setup --> add/remove fixtures" and configure which light not to respond to the black out button by setting a check mark at "Ignore Blackout" for each fixture