I'm confused.
You told us this:
djbluephoenix wrote:
johnny it does work in sound mode (all switches off) and it is patched to address 1 in freestyler
So - I read that the laser works when you activate it for sound in FreeStyler?
Or - did you mean that the laser works when you configure the laser itself for the soundmode?
Also, the DMX 5 to 3 adapter could be a problem. You should check the connections. Read here:
http://www.thedmxwiki.com/definitions/dmx_cables
In short a PIN 1,2 and 3 of the 5 PIN DMX should be connected to PIN 1,2,3 of the 3 PIN DMX connector.
The pins 4 and 5 remain unconnected.
Next to that: an electrical charge could damage the DMX interface partitially. So a flashing LED on the interface does not mean its 100% working.
But, I know the Enttec PRO Interface. Its not that sensitive. So if you think something is damaged, look at the laser, or your cabling.
I know things have been tried earlier, could you do a little test, set these channel values in FS for your laser:
Channel 1: between 102~152 (DMX512 Image mode 1)
Channel 2 to 8: 0
Make sure you have set the laser correctly to respond from DMX channel 1 (DIP 1 up, the rest down).
Does the laser do anything?
When you've set these values, show us the 'output screen' where these values are shown.