fixture_creator_fs4:fixture_creator_-_movement_channel_configuration
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| fixture_creator_fs4:fixture_creator_-_movement_channel_configuration [2023/07/13 06:55] – Jan_K | fixture_creator_fs4:fixture_creator_-_movement_channel_configuration [2023/07/13 07:25] (current) – Jan_K | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| The pan and tilt channel panel are used to control the movement of the fixture.\\ | The pan and tilt channel panel are used to control the movement of the fixture.\\ | ||
| - | This is done with the “Pan/ | + | This is done with the “Pan/ |
| If your fixture only has one of the movement channel, pan or tilt then this are to be controlled with “Custom sliders” as the pan / tilt control requires both channels.\\ | If your fixture only has one of the movement channel, pan or tilt then this are to be controlled with “Custom sliders” as the pan / tilt control requires both channels.\\ | ||
| \\ | \\ | ||
| Line 19: | Line 19: | ||
| \\ | \\ | ||
| Here a 16 bit example.\\ | Here a 16 bit example.\\ | ||
| - | \\ | + | {{: |
| As it can be seen bellow the course part of the control goes into the 8 bit channel and the fine part of the control goes into the 16bit part.\\ | As it can be seen bellow the course part of the control goes into the 8 bit channel and the fine part of the control goes into the 16bit part.\\ | ||
| {{: | {{: | ||
fixture_creator_fs4/fixture_creator_-_movement_channel_configuration.txt · Last modified: by Jan_K