Using TCP commands to control single channel values
Posted: December 14th, 2021, 5:38 pm
Hi all,
I have the TCP commands working, but I don't see any way to control a specific DMX channel value. I run a planetarium with about 100 LED fixtures over art-net and I'm trying to find a way to have fixture specific control. Is this possible using TCP commands?
For example, let's say I wanted to set my 50th fixture, which has channels 150, 151, and 152 for R, G, and B values. Is there a command to set channel 150 to a value of 255 and turn just that one fixture red?
Thanks for any help. I'm looking at a variety of solutions and Freestyler is so close if I could just get per channel control set up.
I have the TCP commands working, but I don't see any way to control a specific DMX channel value. I run a planetarium with about 100 LED fixtures over art-net and I'm trying to find a way to have fixture specific control. Is this possible using TCP commands?
For example, let's say I wanted to set my 50th fixture, which has channels 150, 151, and 152 for R, G, and B values. Is there a command to set channel 150 to a value of 255 and turn just that one fixture red?
Thanks for any help. I'm looking at a variety of solutions and Freestyler is so close if I could just get per channel control set up.