Problem with Pan/Tilt
Posted: October 20th, 2021, 7:56 pm
Hello,
I have a problem with Freestyler, or with Enttec Open DMX driver.
All lights and channels are working properly except Pan/Tilt. When I'm trying to use Pan/Tilt, the beam starting rotates a little and then stops, When I'm trying to use Round or Circle, beam works with cutting.
I've checked outputs, cables, tried to install Freestyler on computer with windows 7 / 64 bit, and Windows 10 / 64 bit, I installed new and old versions of Freestyler also, but the problem is same.
Anyone has any idea?
I have a problem with Freestyler, or with Enttec Open DMX driver.
All lights and channels are working properly except Pan/Tilt. When I'm trying to use Pan/Tilt, the beam starting rotates a little and then stops, When I'm trying to use Round or Circle, beam works with cutting.
I've checked outputs, cables, tried to install Freestyler on computer with windows 7 / 64 bit, and Windows 10 / 64 bit, I installed new and old versions of Freestyler also, but the problem is same.
Anyone has any idea?