Page 1 of 1
More light rays
Posted: December 12th, 2020, 5:49 pm
by colombo
Good day. Is there a way to display two light beams in Magic 3D Easy View? In the Scanlibrary Editor, the Number of light beams option is set, if I set it to two or more, one light beam is still displayed. I found on the forums that it is not possible yet, but it was around 2010. Thanks for the response.
Re: More light rays
Posted: December 14th, 2020, 9:00 pm
by Mattotone
Magic3D is a 3rd party tool that has been abandoned by the developer many years ago.
It still does the job reasonably well but lacks a lot of options that modern software such as capture or WYSIWYG have.
Re: More light rays
Posted: December 30th, 2020, 1:37 pm
by colombo
In my research, there must be at least one PAn or Tilt channel. Then the selected number of beams is displayed. If you have two or more pairs and two or more PAN or TILT channels, then unfortunately all rays move according to PAN1 or TILT1.