submaster intensities programmed to midi fader , response is slow
Posted: 25 Nov 2018, 21:28
Hi All
i have setup the first three submasters to control the dimming of my martin CX4
i midi mapped 1 fader to each intensity slider.
also mapped 1 fader to the master intensity.
the intensity faders in the submasters are not responsive i experience lag when going from 0% to 100%.
both in real life and in the 3d view.
while the master intensity is responding as with an analog table .
i have ruled out that the fault is in my midi controller.
i think there must be some small setting i have overlooked.
i am using version 3.6.38 , never updated to a new one because it was working flawless until i tried the above scenario
id love to hear your thoughts guys , been searching and trying to solve it all day without succes.
best regards maurice
i have setup the first three submasters to control the dimming of my martin CX4
i midi mapped 1 fader to each intensity slider.
also mapped 1 fader to the master intensity.
the intensity faders in the submasters are not responsive i experience lag when going from 0% to 100%.
both in real life and in the 3d view.
while the master intensity is responding as with an analog table .
i have ruled out that the fault is in my midi controller.
i think there must be some small setting i have overlooked.
i am using version 3.6.38 , never updated to a new one because it was working flawless until i tried the above scenario
id love to hear your thoughts guys , been searching and trying to solve it all day without succes.
best regards maurice