Support Forum

Can someone explain why every sequence I program, while going back through the sequences to check before saving, the last scene always copies-doubles if you like.
Why is this and how to stop it?
Thanks in advance.
Goochie

Hej Goochie.

I an not sure if it is this you are aiming at.

if you open the sequence editor then already have the first scene.

If you then press "+" then you have two scenes.


1. open sequence editor
2. make changes
3 don't press "+"
4 save the sequence.

you now have a sequence with only one step.


What I think you are doing.

1. open sequence editor
2. make changes
3. press "+" (you have now added a new scene)
4. save the sequence

you now have a sequence with two identical steps as you did not edit the new step you added with the "+".

I hope it was this you were asking for.

/Jan

Thanks Jan,
I am probably doing what you say, but the problem is always the Last scene seems to copy again.
If I create -say a 30 Scene sequence, when I hit the play button to check it before saving, the very last scene is always a repeat of the previous one, so scene 30 is always a copy of scene 29, that I don't want.
What am I doing wrong?
Thanks.
Goochie.

Don't press "+" when you have made the lase scene in a sequence.

Edit the lase scene and press save.

Don't press "+" and then save.

/Jan

Ah right, that's where I be been going wrong I think.
Many Thanks Jan.
Great advise.