Support Forum • Trying to input from MPC over ARTnet

Page 1 of 1

Trying to input from MPC over ARTnet

Posted: 28 Jun 2016, 22:24

by DJ Higgumz

I have MPC sending data to artnet, but how do I input that data to easyview?

Re: Trying to input from MPC over ARTnet

Posted: 05 Aug 2016, 01:59

by buttza

Are these on the same machine or different machines?

Re: Trying to input from MPC over ARTnet

Posted: 05 Aug 2016, 02:01

by DJ Higgumz

Same machines

Re: Trying to input from MPC over ARTnet

Posted: 11 Aug 2016, 05:58

by buttza

You will need to use the loop through setup.

viewtopic.php?f=56&t=6354