Loss on control
Posted: 16 Dec 2015, 03:22
I've been able to make this happen a few times quite frequently, so I am asking for a little guidanace....
when I first start FS, I am able to control all of my lights. I start a cue, run it for a few minutes, and then stop the cue. As of that point, I cannot send any commands out to my lights with no cues running. The same thing happens if I open the overrides, perform an override, release it, I get the same result. They only way that I can correct it to restart FS. I open the output window and no DMX commands are being sent. I can still runs cues though, I just can't "Program"
I am using a joystick control for the lights and have it mapped out through Logitech's program.
Thanks in Advance!!
when I first start FS, I am able to control all of my lights. I start a cue, run it for a few minutes, and then stop the cue. As of that point, I cannot send any commands out to my lights with no cues running. The same thing happens if I open the overrides, perform an override, release it, I get the same result. They only way that I can correct it to restart FS. I open the output window and no DMX commands are being sent. I can still runs cues though, I just can't "Program"
I am using a joystick control for the lights and have it mapped out through Logitech's program.
Thanks in Advance!!