Support Forum

HI Guys, after a bit of advice,

I've made a sequence. added it to over button, but only the first step will run. Any ideas what IM doing wrong?

IN the club we have movement already set up on override buttons, I'm trying to ad d anew one, but it only goes to the first position then holds there. Am i missing something?

When running it in cue, it runs ok though?

Help please.
Thanks

Override buttons will only show the first step of a sequence. You must run multi step sequences from the cue window or the submasters

Rusty

Thanks Rusty,

IM trying to fix how the guy who installed it all has set it up.

Oddly, there is override buttons with movements on already, any idea how this would happen?

When i open this in the sequence editor it appears to be on step?

the bezier will work since it all take place in 1 step but multi step sequences will not work on overrides

Now that makes sense.

I'm trying to fix what 1 guy has done 1 step at a time. The one who's set it all up has configured everything on overrides.

We're trying to configure it so it's just a screen full of simple buttons but presuming is really need to do this with cue buttons. But what I can't figure out is how to have all the cue buttons on one page. So if I have one set for say gobo. One set for colour. Only one set can be displayed at once?

you need to utilize the submasters for that http://www.freestylersupport.com/wiki/p ... ter_config

The problem with submasters, is I can't program a button that jumps to them can i?

no, that is the problem with Submasters.
Sounds like Cuelists are the way to go, give them a look.