Support Forum

Hi,

I have an moving head with "two heads"(roll heads). Sometimes called spider moving head:

example:
https://www.youtube.com/watch?v=kfBkg9cbjCg

My problem is that it have doubble tilt channels.

1. X 8b
2. X 16b
3. X speed
4. Y1 8bit
5. Y1 16bit
6. Y2 8bit
7. Y2 16bit
8. Y speed

etc...

i'm making a fixture for this moving head right now but in the fixture creator there is only one tilt channel possible. Is it possible somehow to make channel 6 copy movements of channel 4? And channel 7 -> 5? Because, I cant see any need of using these two separately at the moment.

I tried to put channel 6 as 16bit but the result was t.f.u.


Best regards,
Mattias

leave the two channels blank and then patch the channels in freestyler setup

hey did you ever finish the fixture ?
thank you.
mike.