Page 1 of 1
Minimum intensity for dimmer?
Posted: 11 Nov 2013, 18:39
by Photovor
Hi, I have a custom dimmer pack, and when I set it up as a dimmer with a single channel in the fixture creator, everything works ok, but with one small problem. When I select the fixture, and change the intensity, I don't get any light until around 50. I was wondering if there was a way to set it so that 0 in freestyler would equal 50, so my range would effectively be 50-255.
Re: Minimum intensity for dimmer?
Posted: 12 Nov 2013, 00:42
by buttza
You can do that by using the fixture creator.
Open the FS Fixture Creator
PAR64 Folder
Open 1 PAR64L
Then in the intensity channel change Min value from 0 to 48.
PAR64.png
Save file as Custom PAR64 or other name you wish.
That should help.
Re: Minimum intensity for dimmer?
Posted: 12 Nov 2013, 01:10
by Photovor
If I already have the fixture added to a layout will I have remove and add it again? I already tried the suggestion but it didn't seem to make a difference.
Re: Minimum intensity for dimmer?
Posted: 12 Nov 2013, 06:09
by Jan_K
If you use the faders / sliders in right side of FreeStyler and not the lamp control panel then it will have no effect.
The faders in the right side panel always goes from 0 to 255.
The ones in the panels can be limited as buttza shows.
Else have a look in the output monitor panel to see what FreeStyler sends.