Submaster Intensities.

[buttza]

I have a question relating to a previous question I have asked.

I figured out how to use the slider on my Korg NanoKontrol 2 to control the front wash lights however, If I slide up to 50% on the slider it goes to 50%, after about 1 second, the lights go to 100%. This is the default setting in the sequence that is being used on the submaster.

From what I can see when you run it in the cue list, it loops by default. There for when I slide the fader to 50%, the sequence then repeats and pushes it to 100%.

I don't suppose there is a better way to get the fader to be absolute or LTP/HTP on Intensities?

I may have worded this wrong so please don't kill me with fire if you didn't understand my meaning.

[Spirit]

a intensitie Channel normaly works on HTP, thats also the case on FS.

But i know there is someking of issue.. but nor realy, i allreadt told the devolper about it but he says its normal..

But if you use the Submaster intensitie. and do NOT have the Submaster intensitie window OPEN the value will be the one from the Seq.

so to keep it simple. open the submaster window if you dont do that..

/spirit