Support Forum

Hi All,

I'm having this problem, I'll be glad if anyone can provide some insight.

I'm creating sequences for a stage show. I marked down the timing of the music that I want to change the light scene and programmed these times accordingly in sequence creator. However, when I play the sequence at the same time with music, lights don't come alive at the right timing. It comes a little bit early.

For instance all fixtures should light up red at second 5 and then white at second 10 (timing of the music). Although I set up this way, they light up at 4 and 8 or something like that. It makes creating the sequence very difficult and annoying.

What might be the cause of this?

Thanks

uhhmm strange.

a other Member came with the issue last week that 1Step comes down to 1.2 SEC..
as i could confirm this.. also i added a Bug report and the devolper made a FIX.
and it runs fine now.. (Not yet downloadable for Forum Memebers)

so its realy strange it runs slower at your side..

/spirit

Thanks for the reply. That would be great if the can download the FIX. Or at least an idea how it can be fixed so that I can try to change things myself (I know a little about changing stuff in program files -although not much)

(v3.5.4) I'll chime in as well... using the TAP function during a show seems to lag a bit after setting it - now it could very well be the band speeding up or slowing down, but it sure feels like the TAP has a short delay.

I seem to be having this problem with my cues. I initiate the cue via MIDI with Reaper, it starts right on time, but then the sequence will not be consistent. Usually goes too fast, so I adjust the scene times, try again, looks good, then run the show again and it's too slow, as if my original times were correct. This has been a recurrent problem. Is my system to blame? Or is there something I need to fix in FS?

sorry, accidental double post