Support Forum

Hello everyone.

I am trying to make a fixture for a Martin RoboScan Pro 218 mk1.

I have got my hand on a Martin DMX interface as i know the mk1 are non-dmx but i understand with the interface it is possible to use dmx software.

I have tried to make a fixture however all i get is the light re-setting itself.

Can someone look and tell me where i been going wrong?

Thank you!

Hej Ibailey

Know it is a bit late.

I tried to open your file but I get an error.

It says invalid picture.

Try add a image (I don't have to be the right one) and upload it again.

Then I will have a look.

/Jan

You can eventually have a look in this one which I found in the complete fixture library.
It is mode 3

/Jan