Support Forum

I have two scenes loaded in the cue to loop forever, using my other thread image as an example:



When I change the arrow pointing right (forward) to point left (reverse) on the RVS scene, all of a sudden, the reversed scene (RVS) will not run, only the FWD does and loops over and over normally, but the cue will not sequence the RVS scene, when I revert it back to the right arrow, it then cycles FWD, RVS forever with no issue.......I don't understand why? I've converted them from transparent to static to fix my other thread issue but this is a new failure I'm not sure how to fix or why it is happening.

The other issue, when I press the button cue for the first time to start the cue with the loaded scenes in the cuelist buttons (using same image example), BOTH FWD and RVS scene run at the SAME TIME for one iteration then they loop forever one at at time FWD, RVS, FWD, RVS, FWD, RVS.....etc........I know that ain't right but not sure why its doing it. I have it set to start from the 1st scene, but both run simultaneously then one then the other as I would expect.

Any ideas?
Thanks.

I've completely started over thinking it was something I did or some how messup the sequence creation, but I'm still seeing this issue, any idea what I could be doing wrong?

hi can you upload your Backup file so its easyer for us to see whats happening.
/spirit

I've added the file, just hit the cuelist buttons and in the first pass you'll both cues start at the same time......I would expect them to start at 1 and go down the cue list......

Thanks for the help

Chris

ahhh now i undestand what you like to have, without looking at the Backup.

but this is normal, Cuelist buttons is made for Complete Thema's With one press of a Button.

You can also Enable "LOAD CUE ONLY" this will NOT Run any Seq if you press a Cuelist button.

But you like to have it That First Seq1 plays then Seq2 Then Seq3 Then Seq4.

but you can do this With TIMECODE (Elapsed or Realtime)
look at this page :

http://www.freestylersupport.com/wiki/p ... :time_code

/spirit

Ok i'll try to give it a go, but not "solved" yet until I can get it working...



ty