Support Forum

Hello, Brand new to freestyler so excuse if I appear a novice.

I have a parallel port DMX-120 from some years ago, which I didnt use much because the software was very limited.
However my lighting desk is becoming restricted follow the addition of two moving heads taking 15 channels each - so I have decided to investigate software based control.

As I have a DMX interface I should see how far I can go with it before spending hundreds of pounds on a new box.

SO will freestyler work with a parallel DMX-120 and what do I have to do to make it recognize/talk to this box.
Not sure if I have any drivers for it - being a parallel device not sure if there are any drivers applicable?

Advice please.

Thank you

OK Guys, I have been looking and neither my laptop or desktop have Parallel ports!!!
(where did they go? doesn't anyone have printers nowdays)

This means either I have to use a V old computer (which probably wont have a recent enough operating system) or but a DMX interface.

I have decidef to invest in a cheap USB interface to get familiar with Freestyler, then later if I find I like the software but the interface is poor I can upgrade OR I can look at other interfaces with their own software.

Post any comments you like against this so other novices/newbies can see your opinions

Thanks
Roy

PS I noticed a couple of spelling mistakes, it should read
Buy a DMX interface.
I have decided

I have read the FAQ and it says I should be able to edit the post using the edit button - but there is no button I can see/find - If anyone wishes to enlighten me - I would be grateful